Asus Pedestal Server TS100-E4/PI2 - Manual (Page 24)

Chapter 2: Hardware setup 2-6
3. Lift the load lever in the direction
of the arrow to a 135º angle.
4. Lift the load plate with your
thumb and forefinger to a 100º
angle (A), then push the PnP
cap from the load plate window
to remove (B).
To prevent damage to the socket pins, do not remove the PnP cap
unless you are installing a CPU.
5. Position the CPU over
the socket, making
sure that the gold
t r i a n g l e i s o n t h e
bottom-left corner of
the socket. The socket
alignment key should
fit into the CPU notch.
Alignment key
Gold triangle mark
Load plate
A
B
2. Press the load lever with your thumb (A), then move it to the left (B)
until it is released from the retention tab.
Retention tab
Load lever
This side of the socket box
should face you.
PnP cap
A
B