Asus Pedestal Server TS100-E4/PI2 User Manual
Page 30
Chapter 2: Hardware setup
2-12
2. Insert an HDD to the upper bay of
the cage. Make sure that the HDD
screw holes are aligned with the
HDD cage screw holes.
DO NOT install a hard disk
drive to the lower bay of the
cage.
Screw holes
1. Press the HDD cage lock while
pulling the cage out from the
chassis. Place the HDD cage in a
flat surface.
4. Secure the SATA HDD with three
screws as show.
5. Connect the SATA signal and
power cables.
To install the second Serial ATA hard disk drive:
This manual is related to the following products: