ADTRAN 600 Series - Manual (Page 53)

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 53
© 2002, ADTRAN, Inc. Total Access 600 Series User Manual
The following settings are used for FRF8.
L AN FR M AINT P ROTOCOL Frame Relay maintenance or signaling protocol
between local V.35 port and the attached DTE
port, support ANSI Annex A, CCITT Q933 An-
nex D, CISCO LMI or Static (no signaling).
L AN FR P OLL T IMEOUT
T392 (5-30)
T392 for signaling protocol, typical value 15. No
meaning if Maint Protocol is Static.
F R /ATM PVC M APPING Up to 4 mappings are supported.
FR DLCI Frame Relay DLCI on V.35 port.
ATM VPI Specifies the virtual path to which DLCI is
mapped.
$70 9&, Specifies the virtual circuit to which DLCI is
mapped.
T RANSLATE Translate or transparent mode between
Frame Relay frames and ATM cells.
' ( 0 $3 Map Frame Relay DE bit to ATM CLPI bit,
Always 0, Always 1 or Convert each other.
) (&1 0 $3 Map Frame Relay FECN bit to ATM EFCI
bit, Always 0, Always 1 or Convert each
other.