KEPCO KIT 219-0452, BIT 4886 Firmware Upgrade for BOP 100-1M-4886-25968 User Manual
Kepco, Bit 4886 firmware upgrade, Description
Table of contents
Document Outline
- 1. Description
- 2. Installation of Upgrade PROM
- 3. Initialization of the BIT 4886 Card
- 4. BIT 4886 Instruction Manual Changes
- A. Replace PAR. 3.3 Calibration (including Tables 3-1 through 3-3 and Figures 3-3 and 3-4) with t...
- FIGURE 3-2. Current Shunt Connections
- 3.3 Calibration of BIT 4886 Interface Card using the VISA Driver Soft Panel
- 3.3.1 Calibration using the VISA Driver Soft Panel
- FIGURE 3-3. Main Panel
- 3.3.1.1 Calibration Basics
- FIGURE 3-4. Calibration Panel
- TABLE 3-1. Calibration Panel Functions
- 3.3.1.2 Calibration Procedure
- TABLE 3-2. Calibration Measurements and Tolerances - Voltage
- TABLE 3-3. Calibration Measurements and Tolerances - Current
- TABLE 3-4. Suggested Sense Resistors
- B. Replace PAR. 5.2, 5.2.1, and 5.2.2 as follows:
- 5.2 Enhanced Operation
- 5.2.1 Error Detection
- 5.2.2 Limit Channel Control
- C. Replace Table 5-1 to update DIAG: commands and Queries
- Table 5-1. Enhanced Operation - Error Response
- D. Modify Table A-2 to add Bit 6 = Protection Error
- TABLE A-2. Standard Event Status Enable Register and Standard Event Status Register Bits
- E. Add the following to Appendix B
- B.4A CALibrate:CPRotect Command
- F. Modify Table B-5 to add Bit 14 = Protection Error
- TABLE B-5. Questionable Event Register, Questionable Condition Register and Questionable Conditio...