Jenway 6850 - Manual (Page 21)

21
4.3.4.2 Set Date
Highlight the set date option and press the Enter key to confirm. This will allow the user to enter the
current date in the format DD.MM.YY using the numerical keypad and the decimal point keys. Press
the Enter key to confirm. Once complete the instrument will return to the Clock Setup menu.
4.3.4.3 Display Time / Date
Highlight the display time or display date option and press the Enter key to confirm. This will set the
top right hand corner to show the selected option.
4.3.5 Refresh Dark Current
Highlight the refresh dark current option and press the Enter key to confirm. This will re-measure and
store the detectors’ dark current values.
4.3.6 Connect to PC
Connect the interface cable to the USB type B port on the rear of the instrument and connect to a
USB port on the PC. The connecting COM port should be configured with the following settings:
38400 baud 8 data bits
No parity 1 stop bit
Highlight the Connect to PC option and press the Enter key to confirm.
4.3.7 Beeper On/Off
Highlight the beeper on/off option and press the Enter key to confirm. An audible sound will be heard
each time an instrument button is pressed when this option is enabled.
4.3.8 Language Selection
Not currently available.
4.3.9 Refresh System Baseline
Ensure the sample chamber is empty, highlight the refresh system baseline option and press the
Enter key to confirm. This will re- measure and store the detectors’ signals over the full wavelength
range of the instrument.