In-Situ D-cell Lithium Battery Kit for TROLL 9500/9000 and miniTROLL External Power - Manual (Page 2)

Due to continuing product development this information is subject to change without notice. In-Situ and the In-Situ logo, TROLL, miniTROLL,
and AccessPoint are trademarks or registered trademarks of In-Situ Inc. Copyright © 2004-2005 by In-Situ Inc. All rights reserved.
1 800 4INSITU
(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
miniTROLL/Multi-Parameter Water Quality TROLL ®
LITHIUM BATTERY KIT
Catalog No. 48230
0048232 rev. 005 9/05
MP TROLL 9500
1. Unscrew the battery compartment cover and slide it up over the cable (if
attached) to expose the battery compartment.
2. Remove used batteries if present.
3. Insert new batteries, negative side first, positive side up. Do not install the
battery isolation disc in the device.
4. Replace the battery compartment cover and tighten.
If your TROLL 9000 serial number is lower than 031150, please
contact In-Situ Technical Support at
1-800-466-7488 before
proceeding.
Do not use lithium batteries in a TROLL 9000E (the 4-battery model).
ACCESS POINT
miniTROLL External Power
1. If AccessPoint will be pole-mounted, mount it first.
2. Open the cover and install two lithium D cells as
shown.
3. Close and latch the AccessPoint cover.
TM
MP TROLL 9000
1. Unscrew the back end and remove existing batteries.
2. Insert new batteries into the instrument body negative side first. Do not
install the battery isolation disc in the device.
3. Replace the instrument back end. Be sure it is properly seated and
screwed down tight.
TIP: At your next software connection, select the MP TROLL in the
Navigation tree, select Edit... , then Battery Information to update
the battery type and the installation date.
Note: Due to the voltage supplied by two lithium D cells, the software
will report that the MP TROLL is operating on external power.
Batteriy orientation
↓ ↓
Battery orientation
Battery orientation
↓ ↓
TIP: At your next software connection, select the MP TROLL in the
Navigation tree, select Edit... , then Battery Information to update
the battery type and the installation date.
Note: Due to the voltage supplied by two lithium D cells, the software
will report that the MP TROLL is operating on external power.