In-Situ Dissolved Oxygen: Clark Cell Calibration Kit for TROLL 9500 User Manual
Page 4
Due to continuing product development this information is subject to change without notice. In-Situ and the In-Situ logo, Win-Situ, Pocket-Situ,
TROLL, and RDO are trademarks or registered trademarks of In-Situ Inc. Copyright © 2005 by In-Situ Inc. All rights reserved.
1 800 4INSITU
(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Multi-Parameter Water Quality TROLL
®
17
0048672 rev. 002 09/05
TIP: If the units for the reading are not what you expect, it
is easy to change the units selection: In Win-Situ, select
Preferences on the Options menu. In Pocket-Situ, select
the Home site, then tap Setup in the command bar.
TIP: You can look at the calibration report right after
calibrating, or at any time. See “Calibration History” in
Section 10 of the MP TROLL Operator's Manual for more
information on calibration reports.
BUBBLER CAL KIT
Catalog No. 48670, 95150
page 4 of 4
17 To finalize the calibration click Finish.
The values will be written to the sensor and you will be
asked if you want to see the calibration report.
The polarographic D.O. sensor is now calibrated and ready to
take readings. To confirm this, take a reading by selecting the
D.O. sensor in the Navigation tree and clicking the Read
button.
SENSOR SLOPE AND OFFSET
The slope of a properly functioning sensor as calculated
during the calibration process will typically be in the following
ranges, depending on the membrane thickness:
1-mil membrane: between 30 and 67 nA/(mg/L)
2-mil membrane: between 15 and 34 nA/(mg/L)
If the calculated slope is much outside the stated range, the
sensor may need maintenance. Refer to “Sensor Care and
Handling” in Section 13 of the MP TROLL Operator's Manual.
The default offset for Quick Cal and 1-point calibrations is 2
nA. Offsets for 2-point calibrations should fall under 10 nA.
REPLACEMENT PARTS CATALOG NO.
Bubbler housing ......................................................... 48080
Bubbler base .............................................................. 48090
Portable air pump ...................................................... 48730
PVC adapter for MP TROLL 9000 ............................. 48660
PVC adapter for MP TROLL 9500 ............................. 53230
3.028" o-ring for base ................................................ 48260
Check valve ............................................................... 48540
Clamp ........................................................................ 48570
Elbow fittings (3) ........................................................ 48740
Aquarium stone (3) .................................................... 48750
Complete kit for MP TROLL 9000 ............................. 48670
Complete kit for MP TROLL 9500 .............................. 95150