In-Situ Bulkhead Connector for Use with RuggedCable Systems - Manual

Information Sheet
TROLL ® Accessories
(over)
Catalog No. 0053240
bULKHEAD cONNEcTOR
Nut Gasket
Ground
contact
(brass)
Vent tube with
hydrophobic
membrane
Dust cap
RuggedCable ™
with Twist-Lock
connectors
Level TROLL,
Aqua TROLL,or
MP TROLL 9500
AppLicATiON
A panel-mounted bulkhead that mates with Twist-Lock connectors on In-Situ
RuggedCable
™ .
cONNEcTiONs & WiRiNg
1. Drill and tap hole.
• Drill bit: 29/64 (.453)
• Tap: 1/2" - 20 - NF-UNF
2. Remove jam nut and ground contact from connector assembly.
3. Thread connector assembly through drilled and tapped hole, and tighten.
4. Attach ground contact and ground it.
5. Attach jam nut and tighten.
6. Wire conductors per table below. See wiring diagrams on back of sheet.
spEcificATiONs
Output
6-wire plus ground
Environmental Rating IP67
Wire Color Signal Level TROLL, TROLL 9500
Aqua TROLL
Black GND ✔ ✔
Red EXT PWR 8–36 V 8–16 V
Blue 485(+) ✔ ✔
Green 485(–) ✔ ✔
Brown 4-20 mA ✔ NOT USED
White SDI-12 ✔ NOT USED*
*An adapter (catalog no. 0095200) is required for
SDI-12 operation of a TROLL 9500.