GW Instek GDM-8261A Firmware Upgrade Manual - Manual (Page 8)

GDM-8261(A) Firmware Update
8
Ethernet Firmware Update Procedure
Hardware
Configuration
PC Router GDM-8261
Ethernet Firmware
Update Procedure 1. Power off the GDM-8261(A).
2. Remove the GDM-8261(A) Ethernet card from
the rear panel slot.
3. Use the mini jumper to short the J902 pin headers.
J902
4. Re-insert the Ethernet card back into the
GDM-8261(A) rear panel slot.
5. Connect the RJ45 cables to the PC, router and
GDM-8261(A) Ethernet card as shown in the
hardware configuration diagram above.
6. Power up the GDM-8261(A).
7. The Ethernet card will enter into the bootloader
mode. When in bootloader mode, the green LED
on the RJ45 port will turn on and the orange LED
will blink.
Orange LED -
blinking
Green LED- solid
(Note: during normal operation, the orange LED
will turn on and the green LED will blink)