GW Instek GOM-801H - Manual (Page 3)

GOM-801H DC MILLI-OHM METER
USER MANUAL
⎯ ⎯
iv
This cable/appliance should be protected by a suitably rated and
approved HBC mains fuse: refer to the rating information on the
equipment and/or user instructions for details. As a guide, cable of
0.75mm 2 should be protected by a 3A or 5A fuse. Larger conductors
would normally require 13A types, depending on the connection
method used.
Any mounded mains connector that requires removal /replacement
must be destroyed by removal of any fuse & fuse carrier and disposed
of immediately, as a plug with bared wires is hazardous if a engaged
in live socket. Any re-wiring must be carried out in accordance with
the information detailed on this label.
GOM-801H DC MILLI-OHM METER
USER MANUAL
⎯ ⎯
1
1. PRODUCT INTRODUCTION
The Digital Milliohm Meter features with its accuracy and readability. The
circuit of this instrument has equipped with the voltage regulator and
temperature compensation in order for its accuracy not to be influenced by
the unstable AC power source and the alternation of temperature.
The Digital Milliohm Meter is specially produced for the manufacturers of
the low resistor, switch, relay, jacks, plugs, connectors sockets or the electrolytic
capacitor for the QC or IQC purpose, it also can be applied to measure the initial
contact resistance.