SilentKnight VisorAlarm Manager - Manual (Page 6)

VisorALARM Manager – Quick Guide
6
Doc. DM380-I
Rev. 3.0
5. Modifying User Defined Contact-ID Codes
The “User Defined Contact-ID Codes” tab show in Fig 6 shows the set of Contact-ID codes
that are used when the receiver generates internal signals.
Figure 6
Note that neither the mIP/IPDACT devices nor VisorALARM change the signals sent by a
Control Panel. This User-Defined Codes apply only to internally generated signals.
Code Signaled when Account
mIP registration A new mIP/IPDACT device is registered Device accn
mIP installation error The mIP/IPDACT cannot be registered because a device
with another serial number is actually registered Device accn
mIP deleted A mIP/IPDACT has been deleted from the system
configuration Device accn
mIP loss of contact Communication with a mIP/IPDACT device has been lost Device accn
VisorALARM network
error VisorALARM cannot access Internet. The poll to the
monitor-ip-address server has failed 0000
mIP goes to backup The backup receiver has received polls from a
mIP/IPDACT device but the receiver has not detected the
main failure yet. Device accn
mIP configuration error The mIP/IPDACT device has been programmed with a
Main Receiver address that corresponds to a Backup one. Device accn
Group member down One equipment from the cluster of equipments that form
the receiver is down 0000
VisorALARM is down The receiver is down (Main or Backup) because it has no 0000