SilentKnight VisorAlarm Manager - Manual (Page 4)

VisorALARM Manager – Quick Guide
4
Doc. DM380-I
Rev. 3.0
Printer: Line Speed Baud rate for the Serial Printer connected to WAN2/PRN
Printer: Data bits Number of data bits for the Serial Printer connected to
WAN2/PRN
Printer: Stop bits Number of stop bits for the Serial Printer connected to
WAN2/PRN
Printer: Flow Control Specifies if the communications with the Serial Printer require
Hardware Flow Control
Internet Link: Monitoring
address IP Address for a server in Internet used to check that the
receiver has Internet Access
Internet Link: Frequency Number of seconds between two polls from the receiver to
the Monitoring Address.
Enable monitor events Enables/Disables monitoring events in the receiver
Serial Port: Line Speed Baud rate for the Serial Port where automation software is
connected
Serial Port: Data bits Number of data bits for the Serial Port where automation
software is connected
Serial Port: Stop bits Number of stop bits for the Serial Port where automation
software is connected
Serial Port: Flow Control Specifies if the communications with the Serial Port where
automation software is connected require Hardware Flow
Control
Serial Port: Receiver Type Emulated receiver, the currently supported emulation types
are Ademco 685, Surgard MLR2000, Surgard DLR2 and
Radionics 6500.
Serial Port: Receiver Identifier Number for this receiver in the automation software
Serial Port: Line Identifier Number for the unique line of this receiver in the automation
software.
Serial Port: Link Test Timer Specifies the time interval that the receiver waits between
polls to the automation software through the serial port.
Serial Port: Enable
ACK/NACK For the Ademco 685 emulation specifies if the VisorALARM
receiver must wait for acknowledgments when a signal is sent
to the automation software through the serial port.
Serial Port: ACK Char ACK char used for the Acknowledgement when using
Radionics 6500 emulation
Serial Port: Header Char Header char used for start of frames when using Radionics
6500 emulation
Serial Port:: Termination Char Termination char used to end the frames when using
Radionics 6500 emulation
Serial Port: NACK Char NACK char used for the Negative acknowledgements when
using Radionics 6500 emulation
User The user name for management purposes. This is always
“manager”
Password Password for the manager
UD authentication User and Password to be used for access to the remote UD
server.