Fire-Lite ACM-32AF Annunciator Modules - Manual (Page 39)

AEM-16ATF 5. LED and Switch Functions
ACM-16ATF/ACM-32AF Manual PN 51480:A0 02/02/01
39
AEM-16ATF
The following is a description of the various LEDs and switches located on
the AEM-16ATF.
Figure 15 AEM-16ATF Series LED & Switch Locations
Lamp Test Switch - When pressed, it lights all the LEDs (except the On-
line LED) on the expander and sounds the piezo for as long as the switch is
held down.
Inactive LEDs - These two LEDs are not functional on expander modules.
Point-Active LED - Flashes to indicate an active point; after being
acknowledged it glows until reset.
Trouble LED - Flashes to indicate a trouble situation. After being
acknowledged it glows until reset. If communication with control panel is
broken, all trouble LEDs flash.
Control Switch - Functions as a local Lamp Test for the two LEDs
dedicated to this point. Control switches can be used to execute such system
functions as ACKNOWLEDGE, SIGNAL SILENCE, and SYSTEM
RESET. Switches can also be used to control the status of various output
circuits.
A
E
M-1
6A
T
.c
d
r
Lamp Test Switch
Inactive LEDs
Point-Active LED
Trouble LED
Control Switch