Fire-Lite ACM-32AF Annunciator Modules - Manual (Page 30)

4. Installation Mounting Annunciators and Expanders
30
ACM-16ATF/ACM-32AF Manual PN 51480:A0 02/02/01
3. If employing an AKS-1F Key Switch, mount it to the trim plate. Plug
the switch leads to connector J4 on the annunciator.
Figure 11 Annunciator Key Switch
4. Plug terminal blocks on circuit wiring in backbox to connectors on
annunciator.
5. Align the mounting holes on the trim plate with the threaded tabs on
the backbox and secure with the two screws provided. Tighten
securely.
ABF-2F and ABF-4F Backboxes Only.
1. Remove the backing from the gummed label and affix to the trim plate
as illustrated in Figure 9 on page 29.
2. Connect annunciator expander(s) as detailed in "Wiring the Expander
Connections" on page 31.
3. Place the trim plate face down, with the threaded studs facing up.
Position the annunciator and expander(s) over the threaded studs on
the trim plate and secure each with the two nuts and lock washers
provided (see Figure 10 on page 29). Tighten securely.
4. If employing a keyswitch, mount it to the trim plate. Plug the switch
lead to Connector J4 on the annunciator (see Figure 11 on page 30).
5. Plug terminal blocks on circuit wiring in backbox to connectors on
annunciator.
6. Align the mounting holes on the trim plate with the threaded tabs on
the backbox and secure with the screws provided. Tighten securely.
A
C
S
f-
a
kswir
e.cdr
AKS-1F Key
Switch
J4
Connector