Delmhorst Instrument TotalCheck User Manual
Page 9

Copyright
2006, Delmhorst Instrument Co.
Page 9 of 32
Drywall:
1.0%
Concrete:
68 (on the 0-100 relative scale)
Note: The default alarm setting in scan mode is 300.
TO CHANGE THE TEMPERATURE CORRECTION:
TotalCheck defaults to a temperature of 70ºF. As wood temperature increases, its
electrical resistance decreases and indicated moisture content rises. Lower wood
temperatures result in lower indicated moisture content. A correction is necessary if the
wood temperature is outside the range of 50ºF (10ºC) to 90ºF (32ºC). Set the
temperature accordingly and the meter will make the correction.
1. To change temperature use the
keys from the %MC READ screen to
highlight the TEMPERATURE, T: 70ºF. Press the SELECT button to get into the
TEMPERATURE sub menu.
2. To scroll through the temperature settings, use the
keys to scroll up or
down to a higher or lower temperature value. Temperature values will change in
5
F increments.
3. To change between ºC and ºF press SELECT key when the COMP TEMP is
highlighted.
4. After you have selected the appropriate temperature setting, use the
key to
highlight DONE. This will bring you back to the %MC READ screen and you may
begin taking readings.
TO TAKE SCAN READINGS IN BASIC MODE:
1. From the BASIC Main Menu, use the
key to highlight SCAN MODE.
Then, use the SELECT key to get into the SCAN mode main menu.
The meter will display the main SCAN mode main menu, as shown below: