Delmhorst Instrument TotalCheck User Manual

Page 15



2006, Delmhorst Instrument Co.

Page 15 of 32

2. You may begin taking readings by firmly pressing the back of the meter onto

the material.

3. This will display a relative reading that ranges between 0 and 300.

TO SET THE ALARM IN ENHANCED SCAN MODE:

1. If you wish to set the alarm to beep after a pre-selected relative value is

reached, highlight option #1: SCAN MODE from the ENHANCED main menu.
This will bring you to the SCAN screen.

2. Use the



and



keys and highlight ALARM: OFF. Press the SELECT key to

enter the alarm sub menu.

The default status of the alarm is “OFF.” Press the SELECT key to turn it on.

4. After the alarm is turned on, use the



keys to scroll up or down to a higher or

lower alarm value.

5. After you have selected the alarm value, use the



key to highlight DONE. Press

SELECT to get back to the SCAN screen.

Default alarm settings for SCAN mode is 300.

TO TAKE TEMP/RH READINGS IN ENHANCED MODE:

Before entering the RH-T mode, firmly insert the RH/T-S1 sensor into the top of the
meter, making sure to align the pin-out on the DIN connector.

1. From the ENHANCED Main Menu, use the  key to highlight RH-T MODE.

Then, press the SELECT key to get into the RH-T mode main menu.

The meter will display the main RH-T mode main menu, as shown below: