Delmhorst Instrument TotalCheck - Manual (Page 7)

Copyright  2006, Delmhorst Instrument Co.
Page 7 of 32
TO POWER THE METER ON:
To turn the meter on, press and hold the SELECT button for approx. 2 seconds.
The first screen will temporarily display the meter name and the software revision level.
Refer to this revision level whenever you call Customer Service.
The next screen is the MAIN MENU. Use the
 keys to select the desired
function/mode and then press SELECT to activate the function.
METER USE
BASIC AND ENHANCED MODES:
TotalCheck may be used as a BASIC meter, which allows the user to begin taking
readings in either the scan mode or pin mode, without having to set up a job definition.
BASIC mode does not allow for data collection and is the default mode of the meter
upon power up.
Or, TotalCheck may be used in ENHANCED mode, which requires the user to set job
definitions and materials for each location within a job. The meter also stores each
reading in ENHANCED mode to allow for on screen reading recall or download to a PC.
USING THE METER IN BASIC MODE:
TotalCheck is shipped from the factory set to BASIC mode. Use this option if you wish
to use the meter for scan or pin readings without having to set up a job.
Although Basic Mode does not allow for data acquisition, it does allow the user to set the
type of material being tested, and set the alarm to sound if a pre-established %MC is
exceeded.
TO TAKE PIN READINGS IN BASIC MODE:
1. From the BASIC Main Menu, use the key to highlight PIN MODE. Then,
use the SELECT key to enter the pin mode.
2. The meter will display the main %MC READ screen, as shown below: