Delmhorst Instrument Navigator - Manual (Page 17)

Copyright

2007, Delmhorst Instrument Co.
Page 17 of 28
At any time, you may modify Temperature (T), location (LOC), or switch to SCAN mode
(GOTO SCAN).
The EXIT option in both SCAN and PIN MODE menus will cancel the
measurement process and will put the meter in the MAIN MENU.
MAIN MENU OPTIONS:
STORAGE:
1. While in the ENHANCED main menu, use the с т keys to highlight option #4 STORAGE.
2. Press the SELECT key to enter the storage sub menu. There are two available selections in
this menu:
•
STORED READINGS – choose either Pin readings or Scan readings.
1. By using the п р keys you may select which job and location you wish to view.
After you have made your selection, scroll to DONE and press the SELECT key.
Below are three examples of possible screens at this point:
2. A complete record of information per reading will be displayed. You will be able
to scroll through each reading in a room, using the NEXT key.
•
CLEAR MEMORY:
This option will delete all the readings stored in the meter, but will keep the defined job
structures and associated locations and areas in tact.
•
RESTORE DEFAULTS:
This will delete all defined parameters and readings stored in the meter. The meter will be
now set to the factory parameters: T = 70F, Non-insulated probe, Backlight = OFF,
Power-off time = 2 min.