Delmhorst Instrument Navigator User Manual

Page 13



2007, Delmhorst Instrument Co.

Page 13 of 28

TO DEFINE ROOM LOCATION AND MATERIAL DESIGNATION:

1. Using the

с т keys on the CREATE JOB sub menu, highlight LOC DEF and press the

SELECT key.

2. Use the

с т keys to choose different rooms and the п р keys to switch between

“YES” and “NO” options. “YES” means measurements will be taken in that room. “NO”
means that you are not going to test in that room. Residential jobs show a list of 32
rooms as listed below.

Commercial jobs show a list of 32 numerical locations as listed below:

3. With “NEXT” and “BACK” you will be able to scroll five pages of room listings.

APPENDIX A contains the list of all available rooms and the abbreviation used for each
of them.

To save your settings, use

ò key to highlight DONE and press the SELECT key.

Note:

In order to move more quickly through the five pages of room listings,
you may use the

ñ key when the cursor is at the top of a page to bring

you down to the bottom of the next page. By doing this and then using
the

ð key to highlight NEXT you will scroll through the pages more

quickly.

Each room will have up to three “AREAS” for measurements: FLOOR, WALLS and CEILING. If
you choose “YES” for a room you may now select the material used for each location.

1. Press the SELECT key while the cursor highlights that room and the SELECT

MATERIAL menu will be displayed.

2. Using the

п р keys, select the material or species for that particular room.