DeFelsko PosiTector UTG v.2.2 - Manual (Page 19)

Technical Data Technical Data
Conforms to: ASTM E797
19
Returning for Service Returning for Service
Before returning the Gage for service…
1.Install new Alkaline batteries in the proper
alignment as shown within battery compartment.
2.Examine the probe tip for dirt or damage.
3.Perform a Reset (pg.16) and a Zero (pg.6)
If you must return the Gage for service, describe the
problem fully and include measurement results, if
any. Be sure to also include the probe, your
company name, company contact, telephone
number and fax number or email address.
Website: www.defelsko.com/support
Measurement Range*
Single-Echo
Multiple-Echo
0.100" to 5.000"
0.100" to 2.500" 2.50 to 125 mm
2.50 to 60 mm
Resolution 0.001 in. 0.01 mm
Accuracy + 0.001 in. + 0.03 mm
Velocity Range 0.0492 to 0.393 in/µs 1250 to 10,000 m/s
Measurement Rate 3 readings/second
Gage: 0 to 50° C (+32° to +120° F)
Probe: -20° to 55° C (-4° to +131° F) continuous
Material Surface Temp -40° to +150° C (-40° to +300° F)
Operating Range:
*Measurement range is for carbon steel and depends
upon surface condition, temperature and material.
Gage body dimensions:
146 x 64 x 31 mm (5.75" x 2.5" x 1.2")
Battery Life: 80 hours continuous ( >100 hours idle)