DeFelsko PosiTector UTG v.2.2 - Manual (Page 16)

All batches are date-stamped when created, and all
measurements are time-stamped (24 hour format)
when stored into these batches. It is therefore impor-
tant to keep both the date and time current using this
menu button. Alternatively, the date and time can be
automatically updated when the gage is connected
to PosiSoft using the Gage Utilities -> Set Clock func-
tion in PosiSoft.
Set Clock
This menu button converts the display and all stored
readings from inch to mm or vice versa.
Units
16
A more thorough Reset can be performed by holding
the (+) button when the Gage is powered down until
the Reset symbol appears. It performs the same
function as a menu Reset with addition of Units =
inch, and Language = English.
Date and Time are not affected by any Reset. NOTE:
Reset restores factory settings and returns
the Gage to a known, out-of-the-box
condition. It is handy when you want to “start all
over”.
The following occurs:
- all batches are closed and stored measurements
are erased.
- calibration adjustments are cleared and returned
to the Gage’s factory calibration settings.
- menu setting are returned to the following:
Memory = OFF HiLo Alarm = OFF SE Mode = OFF
Reset
Setup Menu Setup Menu
Setup