COSA Xentaur Hygrocontrol Type 86 Ex - Manual (Page 31)

30
If your choice was “Configure (PW)” in the main menu
and was acknowledged with button , you have to use
the same Password as was described by “Calibrate”.
5.4 Configuration
If your choice was “Display Setup” in the main menu and was acknowledged by
button , the display will show:
5.5 Display Setup
-- Configure --
-- Configure --
Display Setup
Password
0000
ambient
Temperature =
The blinking digit may be changed by button .
Button goes to the next digit. If the value of the
ambient Temperature is typed in correct, it will be
stored by pressing button . You may not change
the indicated temperature value by more than 5°C!
22.6 °C
Out Low
= 800
Displ - Bright
Backlight
Language sel
One after the other Data are shown in the same order as
in the submenu Config-Data - but now they may be
changed. To change a value of any choosen Data, you
press button and now you may change the blinking
digit with button and step to the next digit by button .
With button the changed data will be stored.
Only the Serial Number of the Transmitter will not be shown in the Configuration menu
- this number cannot be changed by the user.
The buttons or are used to choose the desired
operation and has to be acknowledged by button .
“Language sel” has only 2 possibilities until now -
“Deutsch” and “English”. If you choose “Backlight”, you
will see the symbol of a bulb. With button or you
may switch on or off the backlight.
If you choose “Displ-Bright” you may may change the
Brightness by buttons or . To judge the brightness
you will see 2 graphs - a circular and a linear one.
Button will bring you back to the upper menu level.
HYGROCONTROL Manual for Type 86 Ex Page
-- Calibrate --