Aposonic A-S0402R21 - Manual (Page 34)

- 34 -
 Numeric
Press these buttons to select the camera.
 COPY ( )
Press this button to copy the Motion settings, including Detection settings, of the
focus camera to all the following cameras. (EX. focus camera is 1, its Motion
settings will be copied to those of cameras 2-4.)
 ESC
(Mouse: Right Click)
Press this button to escape from this screen, and return to Camera Setup display.
If the Save dialog is shown, press ENTER to exit and save, ESC
(Mouse:
Right Click) to exit without saving.
Following is a brief description for each item and its specific operations:
 Duration – response duration to define at most how long (in seconds) the Buzzer
will keep being triggered after motion is detected for this camera. However, the
Buzzer will be reset immediately once the camera returns to normal. Press +/-
buttons to adjust the value (3 seconds - 60 minutes, discrete, ‘-‘ for ‘Forever’).
 Pre-record – to define how long before motion is detected this camera shall be
intensively recorded at Event Record IPS. Press +/- buttons to adjust the value
(0-10 seconds, discrete). Please note that the actual pre-record time may be
shorter than the value set if the total size of the pre-record pictures exceeds the
pre-record buffer size of the system.
 Post-record – to define how long after motion is detected this camera shall be
intensively recorded at Event Record IPS. Press +/- buttons to adjust the value
(0 second - 60 minutes, discrete).
 Buzzer – to activate the internal Buzzer or not when motion of this camera is
detected. Press ENTER or +/- (Mouse: Left click) to check/uncheck this item.
The default setting is “ˇ” - checked.
 Log – to log to event logs or not. Press ENTER or +/-
to check/uncheck this
item. The default setting is “ˇ” - checked.
 E-mail – to send the event e-mail to remote station or not. The e-mail will be
sent to the predefined receivers when the event is triggered. Press ENTER or
+/- to check/uncheck this item. The default setting is “–” - unchecked.
 Detection Settings.. – used to setup the motion detection settings, including
detection area and sensitivity, when motion is detected for this camera. Please
note that the detection area and sensitivity are also used for the Smart Search
information. There won’t be any Smart Search information stored outside