Aposonic A-S0402R21 - Manual (Page 33)

- 33 -
 Record Quality – the record quality for this camera. Press +/- buttons to select
the value (1-9, with 1 the lowest (rough) quality, 9 the highest (fine) quality).
 Event Record IPS – the IPS (Images Per Second) for this camera if Motion event
occurs for this camera. This camera will be recorded at this rate for Post-record
time since the event occurs. (Please refer to the following sections for
Post-record time.) Press +/- buttons to select the value (0 – 25 (PAL) / 30
(NTSC), discrete).
Please note that the total Event Record IPS should not exceed the system
recording capacity (NTSC: 240/CIF, 120/Half-D1, 60/Full-D1; PAL: 200/CIF,
100/Half-D1, 50/Full-D1), or the system will lower the actual rate automatically
at recording.
 Normal Record IPS – the normal record IPS for this camera. This camera will
be recorded at this rate if no event occurs. Press +/- buttons to select the value
(0 – Event Record IPS for this camera, discrete).
6.1.1 Motion Setup
In Camera Setup, press ENTER to call up Motion Setup as shown when the
highlighted option is Motion Settings.. of the camera to setup. The Motion setup
allows the administrator to define how the system responds to the detected motion for
the camera.
The general operations are as below:
 ▲▼
(Mouse: Left click)
Press these buttons to select the items.