Triton 9200 Installation Manual - Manual (Page 16)

1 6
E
NVIRONMENTAL
P
RECAUTIONS
C
HECKLIST
TEMPERATURE/HUMIDITY
1. The unit needs to be in an environ-
mentally-controlled location, with
no extreme fluctuations in tem-
perature or humidity.
Generally, these parameters must
fall within the following ranges:
Temperature
•
10-40 Deg. C
• 50-104 Deg. F
Relative Humidity
•
20% - 80%
• (Non-Condensing)
AC POWER REQUIREMENTS
2. Ensure the following AC power
requirements are met:
"
"
Isolated Ground. An equipment
grounding conductor that is insulated
from the conduit or raceway and all other
grounding points throughout its entire
length. The only points of electrical con-
nection will be at the duplex outlet and
service panel ends of the line.
When installing a SuperScrip terminal, some general environmental
precautions need to be considered. We have discovered that there are
some devices that may interfere with the performance of the unit.
Evaluate the location where the terminal will be installed. To help ensure
proper operation of the unit, ensure the environmental criteria listed in
this checklist are met.
Dedicated source. The SuperScrip AC
power feed will be a dedicated line, to
which no other electrical devices are
connected. The terminals power line will
be wired for a single “duplex”-style out-
let and connected directly to the AC ser-
vice panel.
DEDICATED TELEPHONE
3. Ensure the following telephone-
line requirements are met:
Dedicated line. The telephone line ser-
vicing the SuperScrip will not be a
“party” line or any other shared type
connection.
Before connecting to a PSTN (Public
Switched Telephone Network), check
the national and local PSTN codes to
assure proper connection interface com-
pliance.
Proximity to Interference Sources. The
telephone line must not be in close prox-
imity to “noisy” devices that could in-
duce interference into the terminals com-
munications channel. See the next sec-
tion for addtional information on “inter-
ference sources.”
RF INTERFERENCE
4. Ensure there are no devices near
the terminal that may cause RF in-
terference, such as:
" TVs " Coolers
" Security Devices
" Neon Signs
" Devices with Compressors