Triton ARGO G60 Installation Manual User Manual
Page 6
6
ARGO G60 I
NSTALLATION
M
ANUAL
* IMPORTANT *
AC power for the terminal should come from a
dedicated source with an isolated ground.
Dedicated source
-
The ATM AC power feed will
be a dedicated line, to which no other electrical devices
are connected. The ATM power line will be wired for
a single duplex-style outlet and connected directly to
the AC service panel. (No extension cords)
Isolated Ground
-
An equipment grounding
conductor that is insulated from the conduit or raceway
and all other grounding points throughout its entire
length. The only points of electrical connection will be
at the duplex outlet and service panel ends of the line.
D
EDICATED
T
ELEPHONE
3. Ensure the following telephone-line requirements
are met:
• Dedicated line
- The telephone line servicing
the ATM will not be a party line or any other
shared type connection (fax machines, Point of
Sale devices)
• Proximity to Interference Sources
-
The
telephone line must not be in close proximity to
noisy devices that could induce interference into
the ATM communications channel. See the next
section for additional information on interference
sources.
TCP/IP Connection
4. When using TCP/IP communication, ensure:
• Correct
setup
- A clear path of communication
has been set up for interface with Host/Processor.
• No fi rewalls
- There is no security fi rrewall
that will prevent communication with the Host/
Processor.
RF I
NTERFERENCE
5. Ensure there are no devices near the terminal that
may cause RF interference, such as:
TVs
Coolers
Security devices
Neon signs
Devices with compressors or motors.
**WARNING**
D O N O T A P P LY P O W E R T O T H I S
TERMINAL UNTIL THE INSTALLATION
IS COMPLETE!!
Dimensions listed comply with US Federal ADA Guidelines. For USA installations, check for additional
guidance. For non-USA installations, check regulations relating to the country of install. Dimensions shown
in inches and [millimeters].
D
IMENSIONS