Triton ARGO G60 Installation Manual User Manual

Page 4

ARGO G60 I

NSTALLATION

ANUAL

The site must be prepared by the customer or his agent who is fully conversant with the requirements of
installing ATM equipment. The responsibility for ensuring that the site is prepared in compliance with this
document remains with the customer.

For information and guidance only, a list is provided in general terms of those matters for which the customer
is responsible. The list is not intended to be comprehensive and in no way modifi es, alters, or limits the
responsibility of the customer for all aspects of adequate site preparation.

1. Location of the equipment and site preparation.

2. Site wiring (power, communication). Ensure access will not be hindered by cabinet placement.

3. Location of other equipment that may cause electrical, electromagnetic or heat induced interference.

4. Make building alterations to meet wiring and other site requirements.

5. Install all communication cables, wall jacks, and associated hardware.

6. Provide and install necessary power distribution boxes, conduits, and grounds.

7. Ensure all applicable codes, regulations, and laws (electrical, building, safety) are adhered to.

8. Ensure the environmental requirements of this unit are met.

9. Install the unit at a height which meets the ADA/DDA/CSA accessibility regulations for the state/country

installed. Refer to Appendix B.

TOOLS REQUIRED

Torque wrench adjustable to at least 60 foot pounds, adjustable crescent
wrench or ratchet wrench, hammer, 3/4” (19mm) socket, large fl at
screwdriver, bubble level, 7/16” socket/box wrench, safety goggles, hearing
protection, 1/4” (6mm), 1/2: (12mm) and 9/16” (15mm) carbide-tipped
masonry drill bits at least 6” long, 3/4” heavy-duty electric drill (rotaty
hammer, back support belt, portable vaccuum cleaner, wire brush.

******NOTE:******

The following kit is required, but not supplied. Call number below for
information on availability.

KIT # 06200-00066

Standard anchor kit (four 1/2” x 4 1/2” sleeve-type anchor bolts, 1/2” nuts,
1/2” fl at washers)

SELECTING THE

INSTALLATION LOCATION

Choosing the right location for your ATM is very important. Security concerns suggest a
location that is away from any door or external access point. Ideally, the terminal should
be mounted as close to a back wall as possible. For marketing reasons, however, it may be
desirable to locate the terminal near the front where your customers can easily locate it.
Wherever you decide to locate the terminal, be sure to follow the recommended procedures
for both mounting the terminal and for removing cash when the unit will be unattended.

EQUIRED

ARTS

AND

OOLS

ITE

OMPLIANCE