Allied Telesis AT 8000/8POE - Manual (Page 21)

AT-8000/8POE Layer 2 Fast Ethernet Switch Installation Guide
21
Table 4 describes the Power LED.
Table 4 describes the LEDs for the uplink ports.
Amber A valid link has been established on the port
and the port is operating in 10Base-T mode.
Blinking
amber The port is transmitting or receiving data at
10 Mbps.
Table 3. Power LED
LED State Description
Power Green The switch is powered on and is operating
normally.
Table 4. Uplink Port LEDs
LED State Description
LINK/ACT Off The port has not established a link with an
end node.
Green A valid link has been established on the port
at 1000 Mbps.
Blinking
Green The port is transmitting or receiving data at
1000 Mbps.
Amber A valid link has been established on the port
at 10 or 100 Mbps.
Blinking
Amber The port is transmitting or receiving data at
10 or 100 Mbps.
Table 2. 10/100Base-T PoE Port LEDs (Continued)
LED State Description