Seed Hawk TOOLBAR 2013 45 & XL SERIES - Manual (Page 54)

SEED HAWK® TOOLBAR OPERATOR’S MANUAL 54
7.7 MAINTENANCE SCHEDULE
Item
Procedure Frequency
Reference Notes check lube clean change hours
    
Caster Wheel Plate
grease fittings
 12
DAILY
2 fittings: 1‐top, 1‐bottom
Caster Wheel Plate
gap
 100
1/8 in (3 mm) max
tighten caster bolt if max exceeded
Wheel Hubs
main frame
 100
100 hr or annually
re‐pack bearings or 2 pumps grease
Wheel Hubs
wing
 100 100 hr or annually
Wheel Hubs
packer wheel
 100 100 hr or annually
Seed/Fertilizer Knives
related components
 10/100
10 hr or inspect daily, and,
100 hr or before seeding
Liquid Fertilizer (opt)
main filter screens
 100
100 hr or before seeding, or,
between chemical changes
Liquid Fertilizer (opt)
basket filter(s)
 50
50 hr, or, before seeding, or,
between chemical changes
Liquid Fertilizer (opt)
system flush
 100
100 hr, or, before seeding, or,
between chemical changes
Liquid Fertilizer (opt)
nozzle bodies
 100
100 hr, or, before seeding, or,
between chemical changes
Wings down
(if configured)
 100
at end of seeding season, or,
when stored for long periods of time
Ball Lock Valves
open
 100
at end of seeding season, or,
when stored for long periods of time
Dump Line
open ‐ drain in pail
 100
at end of seeding season, or,
when stored for long periods of time
Hydraulic Cartridges
flow control / relief
 100
at end of seeding season, or,
when stored for long periods of time
Hydraulic Cylinders
cylinder seals
  A/R 10 / A/R
10 hr or daily ‐ inspect
replace as required (A/R)
Tires
air pressure
 10
10 hr or daily
inflate to proper pressure
Opener Pivot Points  annually re‐torque