Seed Hawk TOOLBAR 2013 45 & XL SERIES - Manual (Page 51)

SEED HAWK® TOOLBAR OPERATOR’S MANUAL 51
7.3 CASTER WHEEL GREASE FITTINGS
Lubricate 2 grease fittings, #1 FIGURE 31, DAILY.
NOTE: Two fittings are on top and the other is on the bottom of the caster wheel plate.
7.4 CASTER WHEEL PLATE GAP
Measure gap between caster wheel plates and tighten castle nut every 100 hrs. The gap, “X”,
should not exceed 1/8” (3 mm), FIGURE 31. Adjust gap, if necessary, by tightening castle nut on
top of caster wheel plate assembly.
FIGURE 31
1
X