Seca Analitics 115 - Manual (Page 40)

40 •
later. This must be done the same day as the
weight and height measurement (see
“Entering laboratory data” on page 35).
• If you click on the question mark next to the
Physical Activity Level (PAL) line, a table
appears with PAL values. If you click a value,
it is taken over into the
Measured values
window.
9. On the measured values window, click on OK .
The measurement procedure is complete.
The
Results of examination tab is active.
The results of the examination can be evaluated.
Evaluating results On this tab, you can view the evaluations of all
measurements performed for the patient. In addition to
the measured values for weight and height, waist
circumference and physical activity level, as well as
medical history and the laboratory data also flow into
the evaluation. The results are displayed in evaluation
modules.
NOTE:
This section describes the handling of the
software. For basic information about the
medical content of the evaluation modules, see
chapter “Medical basis” starting on page 51.
The following evaluation modules can be viewed if
weight, height, PAL and waist circumference are
available for a patient.