Mediabridge MWN-WAPR300N User Guide - Manual (Page 9)

MWN-WAPR300N
4
Chapter 2 Product Installation
2.1 Modem to Router Installation (Most Common)
1. Please use only the included power adapter to power your router. (NOTE: Use of
an unmatched power adapter could cause damage to this product).
2. Please connect
the router’s LAN port to your computer with an Ethernet cable and
connect your broadband line provided by your ISP to the
router’s WAN port.
3. By default the Medialink router is set to use a Dynamic (DHCP) connection through
the WAN port so unless you have a DSL Modem that requires the router to use a PPPoE
type setup, then you will immediately have Internet access through the Medialink router.
If you have a PPPoE setup that requires a DSL Username and Password to be entered
into the router proceed to Step 4.
4. PPPoE Setup
a. Open any Internet browser such as Internet Explorer or Firefox.
b. In the address bar, type http://192.168.8.1
, then hit “Enter” on your keyboard.
c. At the prompt enter the default Username (admin) and Password (admin).
d. Select “PPPoE”, enter your DSL Username and DSL Password provided by
your ISP and hit “Apply”
2.2 Router to Router (Access Point Setup)
1.
Connect your computer directly to the Residential Gateway, Wireless Modem