Mediabridge MWN-WAPR300N User Guide - Manual (Page 65)

MWN-WAPR300N
60

Supports hidden SSID function and MAC Address-based access control

Supports WMM to make your audio and video smoother

Supports SNTP

Supports UPnP and DDNS

Supports WDS to extend wireless network

Supports Wireless WAN and allows access to ISP
’s wireless hotspots to share
Internet access with multiple computers or the ability to extend an existing
wireless network via a Wireless Bridge.

Supports Virtual Server functions such as Port Forwarding and DMZ host.

Provides Syslog to record the running status of the router
Appendix 3 FAQ
This section provides some solutions to the problems which may occur during the
router’s installation or usage. The instructions below may help you deal with the
problems. If your problem is not in the list, please visit our website
www.medialinkproducts.com or send an E-mail to [email protected] .
1. Cannot log in to the Web-based Utility of the router after you enter the IP
address in the address field?
Step 1: Check if the router is working correctly, after the device is powered on for a few
seconds, the SYS indicator on the front panel should light up. If it is not, please contact us.
Step 2: Check that the network cables are connected correctly and the corresponding
LED indicator lights up. Sometimes, the indicator lights up, but it does not mean it is
functioning.
Step 3: Run
“Ping” command and check if it can ping the Router’s LAN IP address
192.168.8.1
(open “Command Prompt” and type “Ping 192.168.8.1” and then enter). If it
is OK, please make sure your browser does not access the Internet by proxy server. If
the ping fails, you can press the “RESET” button for 7 seconds to restore to default
settings. And then repeat the ping operation. If it still does not work, please contact us.
2. I forgot the login password and cannot enter the Web-based Utility.
Press the “RESET” button for 7 seconds to restore the Router to default settings.
(UN: admin PW: admin)