LumaSense Technologies M8100SM-EXP - Manual (Page 4)

E 2 T QUASAR Flare Monitors Operation Manual General iv
4.2.4 Powering with 115 Volts AC ........................................................................... 25
4.2.5 Powering with 220/230 Volts AC .................................................................... 25
4.2.6 Powering with 24 Volts DC ...................................................................... 25
4.3 Fusing ..................................................................................................................... 26
4.3.1 Mains ................................................................................................................. 26
4.3.2 Heater ................................................................................................................ 26
4.4 Connection for mA Output ................................................................................... 26
4.5 Connecting the Set Point Relay ........................................................................... 27
5 Operating the M8100PM-EXP ....................................................................................... 29
5.1 Start-Up Operation Checklist, Pilot Monitor (PM) .............................................. 31
5.1.1 Getting Started .................................................................................................. 31
5.1.2 Initial Control Settings....................................................................................... 32
5.1.3 Delay Setting ..................................................................................................... 32
5.1.4 System Gain/Climate Compensation ................................................................. 32
5.1.5 Oscillation on the Analog Meter ....................................................................... 32
5.1.6 Noise Amplification ........................................................................................... 33
5.1.7 Relay Contacts ................................................................................................... 33
5.1.8 Delay Adjust ...................................................................................................... 34
5.1.9 Milliamp Output (+mA / -mA) ........................................................................... 34
6 Operating the M8100FM-EXP ........................................................................................ 35
6.1 Start-Up Operation Checklist, Flare Monitor (FM) .............................................. 36
6.1.1 Getting Started .................................................................................................. 36
6.1.2 Initial Control Settings....................................................................................... 37
6.1.3 Delay Setting ..................................................................................................... 37
6.1.4 System Gain/Climate Compensation ................................................................. 37
6.1.5 Oscillation on the Analog Meter ....................................................................... 37
6.1.6 Flare Monitor (FM) ............................................................................................ 37
6.1.7 Noise Amplification ........................................................................................... 38
6.1.8 Relay Contacts ................................................................................................... 39
6.1.9 Delay Adjust ...................................................................................................... 39
6.1.10 Milliamp Output (+mA / -mA) ........................................................................... 39
6.2 Considerations for the Flare Monitor (FM) ......................................................... 39
7 Operating the M8100SM-EXP ....................................................................................... 41
7.1 Start-Up Operation Checklist, Smoke Monitor (SM)........................................... 43
7.1.1 Getting Started .................................................................................................. 43
7.1.2 Initial Control Settings....................................................................................... 44
7.1.3 System Gain/Climate Compensation ................................................................. 44
7.1.4 Set-point ............................................................................................................ 44
7.1.5 Relay Contacts ................................................................................................... 44
7.1.6 Delay Adjust ...................................................................................................... 44
7.1.7 Milliamp Output (+mA / -mA) ........................................................................... 45
7.1.8 Final Steps .......................................................................................................... 45
7.2 Considerations for the Smoke Monitor .............................................................. 45
8 Troubleshooting ............................................................................................................ 47
8.1 Problem Isolation Checkout Procedure ............................................................... 47
8.1.1 Sight Path and Optical Alignment .................................................................... 47
8.1.2 Power Input ....................................................................................................... 47