User manual, Camera setup, Record setup – LT Security LTD9056M6 User Manual
Page 9: Record frame rate

User Manual
7
5.3
Camera Setup
Note:
If a camera channel is set to OFF, it will not be recorded (Refer to 6.4 Record Setup)
5.4
Record Setup
5.5
Record Frame Rate
Press [▲, ▼, ◄◄or ►►] button to select a channel, and then press [SEL] to increase the
value or press [■STOP] to reduce the value.
Note
: Higher frame rate shows smooth images, but requires more hard drive space.
Camera Setup allows you to turn cameras on or
off.
Press [▲, ▼, ◄◄ and ►►] buttons to select a
channel and then press [SEL] to modify the setting
ON or OFF.
The total frame rate is 50fps (PAL) or
60fps (NTSC). You can set the frame rate for the
channel which you select to record. If the sum of
the frame rate you select for all cameras is more
than 50fps (PAL)/60fps(NTSC), the DVR will
automatically adjust the largest frame rate value
to a smaller value.
Record Setup allows you to set up recording
channels.
Press [▲, ▼, ◄◄and ►►] buttons to select a
channel, and then press [SEL] to modify the setting
to ON or OFF.
If a channel is disabled in Camera Setup, it will
not record and the DVR will display “NOCAM” on
screen.
1 ON 2 ON
CAMERA SETUP
3 ON 4 ON
( )MOVE (SEL) SELECT (MENU)EXIT
1 ON 2 NOCAM
RECORD SETUP
3 ON 4 ON
( )MOVE (SEL) SELECT (MENU)EXIT
1 3FPS 2 5FPS
RECORD FRAMERATE
TOTAL 36FPS
3 25FPS 4 3FPS
( )MOVE (SEL) + (
■
)- (MENU)EXIT