LT Security LTD2316SE-SL - Manual (Page 27)

21
Digital Video Recorder User Manual
4.3.2 Record stream
Step1: enter into system configuration record
configuration record bit rate; refer to Fig 4-12:
Step2: setup fps, resolution and quality
Step3: user can setup all channels with same parameters.
Tick off “All” to do relevant setup.
Note: if the rate value set is over high the maximum
resources of the device, the value will be adjusted
automatically.
Fig 4-12 record configuration-record bit rate
Definitions and descriptions of Record stream:
Parameter Meaning
Rate Range from: 1-30
（NTSC）1-25(PAL)
Resolution Support CIF
Quality The higher the value is, the clearer the recorded image is. Six options: lowest, lower,
low, medium, higher and highest.
4.3.3 Time
Step1: enter into system configuration record configuration time; refer to Fig 4-13:
Pre-alarm record time: the record time before event happen i.e. record time before motion detection or sensor alarm is
triggered.
Post-alarm record: set the post recording time after the alarm is finished, five options: 10s
、15s、20s、30s and 60s.
Expire time: the hold time of saved records. If the set date is overdue, the record files will be deleted automatically.
Step2: user can setup all channels with same parameters, tick off “all”, then to do relevant setup.