LT Security LTD6299 User Manual
Page 40
- 39 -
Duration – response duration to define at most how long (in seconds) the Alarm Out
relay and the Buzzer will keep being triggered after this alarm input is triggered.
However, the Alarm Out relay and the Buzzer will be reset immediately once this alarm
input returns to normal. Press +/- buttons to adjust the value (3 seconds - 60 minutes,
discrete, ‘-‘ for ‘Forever’).
Goto Preset – to define the preset position to go to for the Focus Camera if this alarm
input is triggered and the Focus Camera is a PTZ camera. For more details about preset
locations, please refer to Chapter 7 PTZ Control.
Pre-record – to define how long before this alarm input is triggered the Focus Camera
shall be intensively recorded at Pre-record IPS. Press +/- buttons to adjust the value
(0-60 seconds, discrete). Please note that the actual pre-record time may be shorter than
the value set if the total size of the pre-record pictures exceeds the pre-record buffer size
of the system.
Post-record – to define how long after this alarm input is triggered the Focus Camera
shall be intensively recorded at Event Record IPS. Press +/- buttons to adjust the value
(0 second - 60 minutes, discrete).
Alarm Out – to define which Alarm Output will be triggered when this alarm input is
triggered. Press +/- buttons to select none (N/A) or one of the Alarm Outputs (1-4).
Buzzer – to activate the internal Buzzer or not when this alarm input is triggered. Press
ENTER or +/- to check/uncheck this item. The default setting is “ˇ” - checked.
Log – to log to event logs or not. Press ENTER to check/uncheck this item. The
default setting is “ˇ” - checked.
Screen Message – to display the event message on the screen or not. Press ENTER
to
check/uncheck this item. The default setting is “ˇ” - checked.
E-mail – to send the event e-mail to remote station or not. The e-mail will be sent to the
predefined receivers when the event is triggered. Press ENTER to check/uncheck this
item. The default setting is “–” - unchecked.