Hired-Hand RS-300 Door: Conversion From Tube Motor To Manual Chain Drive - Manual (Page 2)

ROLLSEAL, INC. • 1751 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-7000 • Fax 256-287-7010
Manual Part No. 4801-3005 Rev 9-05 Page 2 of 2
9. Insert Manual drive shaft assembly into Drive Pipe as
shown in Figure 3.
10. Drill four holes (3/16" dia.) around Drive Pipe for
mounting stainless steel pop rivets as shown in
Figure 3. Space holes evenly around drive pipe.
11. Install 3/16" stainless steel pop rivets to Drive Pipe.
12. Assemble the End Bracket, the Chain Guide Bracket
using the 1/4X20X5/8 Screws. See Figure 4.
13. Install End Bracket Assembly by sliding bearing over
shaft. Attach Chain Guide Wheel and Chain.
15. Install the Chain Keeper as shown in Figure 5.
16. Conversion Complete.
Chain Keeper
Figure 5
Manual Drive
Assembled
Cover
Curtain panel
Manual Drive
(3017-8000)
Chain
Figure 4
Exploded View
Manual Drive
Drive Pipe
End Bracket
(6421-9630)
Chain Guide Wheel
Chain Guide Bracket
Bushing
(0406-4747)
¼x20x5/8 Screw
(1004-6021)
Lock Nut
(1001-1446)
Washer
(1003-2601)
Bolt
(1004-7077)
Table 1 RS-300 End Drive Kits
Part Number Description
6450-7603 /KIT RS-300 Chain Hoist Right
6450-1800 /KIT RS-300 Chain Hoist
Conversion
NOTE: Installation requires both Right
Chain Hoist plus Conversion Kit.
Pop-Rivets
(1005-0100)
Figure 3
Exploded View Drive Shaft
Drill four evenly
spaced holes.
Drive Shaft
(0411-4746)
Dowell Pin
(1048-2980)
Drive Collar
(0406-4745)