Hired-Hand Mega-Cool: Mega-Cool Pad Extender Kit - Manual (Page 2)

Hired-Hand Mfg., Inc. • 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Sheet Part No. 4801-5136 Rev. 12-04 Page 2 of 5
Directions
Assemble the Pipe
Support Brackets to the Bottom
Extender Brackets as shown to the
right.
Bottom Extender Bracket
0404-4658
Item Part Number Description
1 1001-1457 NUT Lock 3/8" NI hx z
2 0404-3238 FAB GS Washer 3/8” X 1" OD
3 1004-0125 SCREW Lag ¼” X 3” hx z
4 1004-7017 SCREW CAP 3/8”-#16 X 5” hx z
WOOD INSTALLATION
Item Part Number Description
1 1004-6024 SCREW ¼” X 1¼” hx z tapcon anc
CONCRETE INSTALLATION
Item Part Number Description
1 1004-0050 SCREW SM #14 X 1” hx tek z
METAL INSTALLATION
STEP 1
STEP 2
Select the appropriate hardware
for installing the Bottom Extender Brackets
on either WOOD, METAL or CONCRETE.
For wood installation, first mark, drill and install the two lag screws (Item # 3). Then
mark the locations for the four cap screws (Item #4), drill through the wood and install
washers and nuts.
Pipe Support Brackets
0404-3444
Item Part Number Description
1 1004-1401 SCREW CAP ¼”x1/2” hx z
2 1001-1446 NUT LOCK ¼”-20 N/I hx z
METAL INSTALLATION