Figure 5: install guard to cone, Figure 6: attach bracket to fan – Hired-Hand Mega Flow SlantWall Fans: METAL CONE Installation Rev 9-05 User Manual
Page 3
HIRED-HAND MFG., INC.
• 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-5128 Rev 9-05………………………………………………………………..Page
3
of
4
7. Carefully lift the attached panels and wrap panels into
cone shape as shown in Figure 5. Attach final corner
bracket with 1/4" bolts & nuts to fasten cone together.
The assembled cone with corner brackets should now
appear as in Figure 5.
8. Disconnect all electrical power from fan.
9. Carefully lift & support cone assembly. Fit cone into
position over outside of fan orifice on exhaust side of fan.
At this point, tighten bolts & nuts as required to achieve a
tight fit of cone around orifice.
10. Carefully lift the attached panels and wrap panels into
cone shape as shown in Figure 5. Attach final corner
bracket with 1/4" bolts and nuts to fasten cone together.
The assembled cone with corner brackets should now
appear as in Figure 5.
11. Disconnect all electrical power from fan.
12. Carefully lift and support cone assembly. Fit cone into
position over outside of fan orifice on exhaust side of fan.
At this point, tighten bolts and nuts as required to achieve
a tight fit of cone around orifice.
13. While supporting cone assembly, attach a top corner
bracket to fan housing. Position bracket, install 1" TEK
screws into fan housing through holes in bracket. See
Figure 6.
14. Repeat Step 10 to attach corner bracket to opposite
corner of fan housing. Cone assembly should now hang
in place.
15. Attach two remaining corner brackets of cone to fan
housing with 1" TEK screws.
16. Install wire guard (supplied) to cone. Align wire guard
with four mounting holes in cone. Install cap screws,
washers & nuts to guard.
17. Reconnect power to fan.
18.
Cone installation complete.
Attach corner
bracket with
TEK screws.
Figure 6: Attach Bracket to Fan
Install wire guard with 90
°
bend pointed toward
inside of cone.
Wire guard
Final Step
Tighten
Bolts
Figure 5: Install Guard to Cone