Hired-Hand Baffles, Vents, & Inlets: Vent Kit for Generation Structures - Manual (Page 5)

HIRED-HAND MFG., INC. • 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-5370 rev 6-04 Page 5 of 8
ROPE / CABLE BRACKET
INSTALLATION
10. The Rope / Cable Attachment Bracket is flat and
preattached on one end for shipment. Refer to
Figure 10. Bend the bracket as shown in Figure 11
and align the bracket holes over the two predrilled
holes in the vent door. Attach using two pop-rivets.
11. When the rope or cable source is located to the right
of the vent door, install the pulley into the left slot
OR with a left source, install the pulley into the right
slot. Attach the rope or cable to the Cable Bracket,
feed through the pulley, and insert the pulley into the
appropriate bracket slot. Refer to Figures 12 and
13.
Rope / Cable Bracket
Preattached side
FIGURE 10
Rope / Cable Bracket
(Formed and Attached)
Pop-Rivets
FIGURE 11
Pulley Installed for
RIGHT PULL SOURCE
Attach Rope
FIGURE 12
Install Pulley
in Left Slot.
Rope / Cable
Source
FIGURE 13
Pulley Installed for
LEFT PULL SOURCE
Attach Rope
Install Pulley
in Right Slot.
Rope / Cable
Source