Hired-Hand Baffles, Vents, & Inlets: Ridge Vent Assembly Instructions - Manual (Page 2)

HIRED-HAND, INC. • 1733 Co Rd 68 • Bremen, AL 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-5204 rev 9-03 Page 2 of 2
10’ Ridge Vent Assembly
The 10’ Ridge Vent assembles the same as the 4’ model
except for the addition of two middle support brackets.
NOTE
The End Caps have four lower screw holes for
attachment to the Bottom End Flashing; The Middle
Support Brackets do not have lower screw holes.
10’ Ridge Vent Components
Parts List for 10’ Ridge Vent
Part Number Qty Description
6450-5098 1 10' Ridge Vent Kit
0404-5991 1 10' Ridge Vent Cover
0404-2005 2 10' Ridge Vent Wire Screen
0404-5221 2 Ridge Vent Bottom End Flashing
0404-5222 2 Ridge Vent End Cap
0404-5992 2 10' Ridge Vent Side Panel
1004-1130 56 Screw 8-15 x 1/2 Hex
0404-5990 2 10' Ridge Vent Middle Support
xxxx
Vent Cover
0404-5991
End Cap
0404-5222
Middle Support
0404-5990
Side Panel
0404-5992
Bottom End
0404-5221
FIG. 7
Wire Screen
0404-2005
(Not Shown)