HATZ Diesel 1B 50 - Manual (Page 32)

7.3 Setting the speed control
Safety note
CAUTION
Damage to the diesel engine due to inadequate lubrication.
▪ After the engine has been out of use for an extended period
(approx. 6 months or longer) or when the engine is first tak-
en into service, operate the engine at a low set speed and
without a load for approx. 20 seconds after starting. This en-
sures good lubrication of all bearing points before the speed
and load are increased.
Overview
Procedure
Step Activity
1 First move the speed control lever (1) to the "Stop" position.
2 Depending on the possibility or requirement, place the speed
control lever in either the "1/2" or "Start" position.
Note:
A lower speed setting will cause less exhaust smoke when start-
ing.
7.4 Starting the engine
Starting options
The standard equipment of the engine is a hand start mechanism. A starter
can be installed as an option.
If possible, separate the engine from the machine being driven by uncou-
pling it. Always switch the machine into idle mode.
Operation and use 1B20, 1B27, 1B30, 1B40, 1B50
32 Operator's Manual 1B20-1B50 HATZ