Elitegroup E07EI1 - Manual (Page 52)

46
• Try restarting the system.
The characters on the screen repeat while I type.
• You may be holding the keys down too long while you’re typing.
• Keep the keyboard clean. Dust and dirt under the keys could
cause them to stick.
Memory Problems
The POST does not show an increased memory capacity
when you have already installed additional memory
• Certain brands of memory module may not be compatible with
your system. You should ask your vendor for a list of
compatible DIMM.
• The memory module may not be installed properly. Go back to
Chapter 4 to review the details of this operation.
• The memory module may be defective.
The O/S issues an insufficient memory error message during
operation
• This is often a software or Operating System-related problem.
A program is draining the memory resources.
• Close the application programs you’re not using and restart the
system.
• You need to install additional memory module. For instructions,
go to Chapter 4 Upgrading Your Computer.
Network Adapter / Ethernet Problems
The Ethernet adapter does not work
• Make sure the physical connections on both ends of the cable
are good.
• The hub or concentrator may not be working properly. Check to
see if other workstations connected to the same hub or
concentrator is working.
The Ethernet adapter does not appear to operate in the
100Mbps transmission mode
• Make sure the hub you are using supports 100Mbps operation.
• Make sure that your RJ-45 cable meets the 100Base-TX
requirements.