Elitegroup E07EI1 - Manual (Page 44)

38
3. Gently lift the old module and replace it with the new one.
When you do this, be sure that the flash module
connector is properly seated on the main-board, as the
connector may be attached to the old flash module. The
connector is what links the flash module to the system
board.
4.
Re-attach Screw A.
5.
Put the metal cover and the keyboard back to their
original position. Make sure the bottom edge of the
keyboard now resides under the spring-loaded latches.
You may need to use a small pin to push the latch in first,
before you lower the keyboard.