Davey SP800-20,30 Single/3 phase SPAPOWER CONTROLLER - Manual (Page 4)

8.5 Display Reversing
The display can be reversed so it can be read from inside or outside of the spa pool, the display will
revert back to default state after 30 minutes of inactivity.
Mon, 12:00
PM
C
Set temp 37.00
O .
3 6 75
Mon, 12:00
PM
C
Set temp 37.00
O
.
36 75
Default Display Orientation Reversed Display Orientation
To reverse the display press the UP and DOWN buttons simultaniously
To restore the display press the UP and DOWN buttons again.
Page 31 Page 2
1.3 LED Indicators
Auto Icon/ Water Icon
Heater Icon
Sleep Icon
Ozone Icon
Auto (Non-24HR circ model) This LED is green when automatic control is enabled and off when pump 1 is under
manual control. In automatic “PUMP AUTO” pump 1 runs as required to heat the pool and ensure minimum filtration
times are met. If the indicator is blinking it means that the water sensor is not detecting any water in the heater
housing. If no water is being detected the LCD Display will also show “WATER PRIMING, PLEASE WAIT”.
Water (24HR circ model) This LED is green when water is detected. If the indicator is blinking it means that the
water sensor is not detecting any water in the heater housing. If no water is being detected the LCD Display will also
show “WATER PRIMING, PLEASE WAIT”.
Heater This LED shows when the heater is on. The heater will turn on and off as required whenever the pump is
running.
Sleep This LED is on whenever the controller is within a designated sleep period. When the controller is asleep the
LED is green but the LED colour will change to orange if manually awoken. During the sleep state the LCD Display
will also show “SLEEPING, PRESS ANY KEY”.
Ozone This LED is green whenever the ozonator (if fitted) is on. Pressing any touch pad button may automatically
turn off the ozonator (depending on installer configuration). If this occurs, the ozonator will not switch back on until
approximately 30 minutes after the last touch pad button press.
8.6 Language Selection
SET ( ) ( )
- - - -
ENGLISH
Scroll to SET
(
Use the UP or DOWN buttons to select language then press the SCROLL button to set.
The SP800 spa controller can be set to display English (default), French, German, Spanish, Dutch &
Japanese.
To select language press and hold the DOWN button for 4 seconds.