Davey SP800-20,30 Single/3 phase SPAPOWER CONTROLLER - Manual (Page 16)

Page 14
Push 1
38.00
1. SET TEMP
O
( SET ) ( ) ( )
C O
1. SET TEMP
2. USER TIMER
3. CLOCK
4. USER ALARM
5. SLEEP TIMES
6. MAINT TIMERS
7. MISC OPTIONS
8. ADV. OPTIONS
9. LD. DEFAULTS
Scroll to SET
Select MAIN menu then push UP button once
7.2 Set Temp (Temperature control)
The SP800 automatically controls the main pump and heater to filter the water and maintain it at the desired
temperature set by the user. The user can leave the system to look after the spa and know it will be at the correct
temperature whenever he or she wants to use it.
While viewing the set temp menu item, the current set temperature is displayed on the four numerical digits in
degrees Celsius (default 37.00). The range of adjustment is 10.00 to 41.50 in steps of 0.25 degrees Celsius.
To change the setting press SCROLL while viewing the set temp menu item. The current setting will flash indicating
that the value may now be changed. Use the UP and DOWN buttons to adjust the set temp as required. Hold down
either button for automatic key press repeat. Press the SCROLL button once the desired value is reached. The final
press of the SCROLL button will return you back to the default view (out of the menu system) and the new setting will
take effect immediately.
Note: The pool temperature will be maintained close to the set temperature, but how close depends upon the “Heat
Control” setting (see section 7.9.2 for more details).
Push 5
5. SLEEP TIMES
- - - -
(SUBMENU) ( ) ( )
1. SET TEMP
2. USER TIMER
3. CLOCK
4. USER ALARM
5. SLEEP TIMES
6. MAINT TIMERS
7. MISC OPTIONS
8. ADV. OPTIONS
9. LD. DEFAULTS
1. SLEEP START
DAYS: [ MTWTFSS ]
11 00
PM
:
Page 19
Select MAIN menu then push UP button five times
SLEEP TIMES
- - - -
(ESC) ( ) ( )
2) Use the UP and DOWN buttons to select the desired sleep period.
Sleep period (1-9)
3) Press SCROLL to start modifying the sleep start day.
7.6 Sleep Timer
Sleep is a very handy feature that is used to silence the spa pool during your hours of sleep. While the SP800 is
asleep no automatic heating or filtration maintenance will occur, however the spa can still be used in manual mode
without having to change any settings.
There are a total of nine individual sleep times that can be programmed, each of which can operate on one or more
specified weekdays. You may use as few or many of the sleep periods as you wish.
By default the spa will sleep between 11pm & 7am, Monday to Sunday. This is achieved using only sleep period one,
the remaining eight sleep periods are disabled.
To review the current sleep settings simply select the sleep time submenu from the main menu. Within the submenu
use the UP and DOWN buttons to browse through each of the nine sleep periods
Each of the nine sleep periods consists of a weekday setting, start time and stop time. These three settings are
displayed using two sleep time submenu items: “#. SLEEP START” and “#. SLEEP STOP” (where # is the sleep
period number 1 to 9).
1) Select the SLEEP TIMES submenu by pressing the SCROLL button.
Follow these steps to set an unused sleep period, or to modify an enabled sleep period.
7.6.1 Configuring A Sleep Time