Brocade Network Advisor SMI Agent Developers Guide v12.3.0 - Manual (Page 122)

106 Brocade Network Advisor SMI Agent Developer’s Guide
53-1003159-01
Alert indications
4
TABLE 14 Supported alert indications
Message ID Trigger Property Value
FC1 One of the following:
•
Zoning database merge was
completed.
How to trigger: Create a zoning
configuration on two switches. Connect
the two switches through an E_Port.
•
Configuration was saved into
persistent store.
How to trigger: Change the zoning
configuration and save the configuration.
You can also do this through the CLIs
zoneadd and cfgsave.
•
Configuration was disabled and now
the previously active configuration is
inactive. Note that when a zone
configuration is disabled and the
default zoning mode is set to
NoAccess, then the zone
configuration is enabled and the
ConfigEnabled indication is
delivered.
How to trigger: Disable the zoning
configuration. You can also do this
through the CLI cfgdisable.
•
Configuration changes made were
committed.
How to trigger: Commit zone changes
using the CLI cfgsave or using the SMI
Brocade_ZoneService.SessionControl
extrinsic method.
Query: SELECT * FROM
CIM_AlertIndication WHERE
OwningEntity=SNIA and MessageID=FC1
AlertingManagedElement COP of Brocade_Fabric
AlertingElementFormat COP
AlertType Device Alert
OtherAlertType N/A
AlertSubType Database Change
Completed
PerceivedSeverity 2 (Informational)
ProbableCause 123
SystemCreationClassName Brocade_Fabric
SystemName Fabric WWN
ProviderName Brocade_AlertIndication
Provider
OwningEntity SNIA
Message Zone database changed
for
MessageArguments Fabric, Fabric WWN