Brocade Network Advisor SMI Agent Developers Guide v12.3.0 - Manual (Page 121)

Brocade Network Advisor SMI Agent Developer’s Guide 105
53-1003159-01
Chapter
4
Indications
In this chapter
• Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 105
• Alert indications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 105
• Life-cycle indications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150
Introduction
The Brocade Network Advisor SMI Agent delivers events in the form of two types of indications:
alert indications and life-cycle indications.
Alert indications are used to represent all fabric events. To receive the alert indications, the clients
must first register with SNMP traps.
Life-cycle indications are delivered by the classes in reaction to a change in the status of a
connection such as, when elements (for example, switch or node) leave or join the fabric.
The Configuration tool allows you to enable mutual authentication for indications. If this is enabled,
all the indications are received over the HTTPS port. By default, the HTTPS is enabled without
mutual authentication.
Alert indications
Table 14 explains the supported alert indications.