Brocade Mobility RFS4000 Controller Installation Guide (Supporting software release 4.3.0.0 and later) - Manual (Page 36)

Country selection
5
26 Brocade Mobility RFS4000 Controller Installation Guide
53-1001933-02
Country selection
Select only the country in which you are using the device. Any other selection will
make the operation of this device illegal.
Laser devices - Gigabit Ethernet SFP option
Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser
Notice No. 50, dated July 26, 2001.
EN60825-1:1994+ A1:2002 +A2:2001
IEC60825-1:1993+A1:1997+A2:2001
The laser classification is marked on the device.
Class 1 Laser devices are not considered to be hazardous when used for their
intended purpose. The following statement is required to comply with US and
international regulations:
CAUTION
Use of controls, adjustments or performance of procedures other than
those specified herein may result in hazardous laser light exposure.
Radio frequency interference requirements - FCC
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular
!
MobilityRFS4000ControllerInstallGuide.book Page 26 Friday, June 10, 2011 1:32 PM